Klüber Klübertemp GR M60 is a long-term grease for a wide temperature range
– Long component life
– over a wide service temperature range
– in contact with aggressive media
– where sensitive plastic materials are used
Klübertemp GR M greases are white, odourless, long-term greases based on perfluorinated polyether (PFPE) oils and polytetrafluoroethylene (PTFE) thickener. The extremely high viscosity index, i.e. the very flat viscosity curve of the base oils, allows excellent sliding friction properties across a wide service temperature range. Klübertemp GR M greases show a neutral behaviour towards most plastics and elastomers and can therefore be used for a variety of component materials.
Klübertemp GR M greases are preferably used for the lubrication of electromechanical actuators, small gears and seals where they show low breakaway torques, exceptionally low friction values as well as a reduced tendency to stickslip.This leads, for example, to lower frictional heating of elastomers subject to dynamic loads and hence longer component life. General behaviour towards elastomers and plastics Lubricants based on perfluorinated polyether oils and polytetrafluoroethylene are generally regarded as neutral towards most elastomers and plastics (possible exception: highly fluorinated rubber). Nevertheless, compatibility with the materials should be tested, especially prior to series application.
For optimum lubrication results, we recommend cleaning the friction points with white spirit 180/210 followed by Klüberalfa XZ 3-1. Then blow the surfaces with clean, dry air or hot air to remove solvent residues. For initial lubrication, the friction points must be clean and bright, i.e. free from oil, grease, perspiration and contamination. Klübertemp GR M greases may be applied directly or by means of brush, spatula or lubricant dispenser. The technical sales departments at Klüber Lubrication may be contacted at any time for advice to ensure optimum service life results.
© 2020 ILS Pty Ltd. ALL RIGHTS RESERVED.