Elaskon MS Polymer dunkel is a sprayable seam seal for car body, ventilation and air conditioning, metal construction, etc.
Elaskon MS Polymer dunkel is elastic, good moisture, weather and temperature resistant from -40 ° C to + 80 ° C (short-term up to 120 ° C). Good adhesion to wood materials, thermosets (except PE, PP, PTFE) and mineral substrates, on glass, many metals (zinc, aluminum, steel), lacquers and primers. It is elastic, good moisture, weather and temperature resistant from -40 ° C to + 80 ° C (short term up to 120 ° C).
Elaskon MS polymer dunkel surfaces must be clean, dry and free of grease. The product can be sprayed with many paints immediately after application (experience up to 2 hours). After some time, adhesion problems may occur with some varnish systems. POP copolymer, one-component, moisture-curing and solvent-based. Screw the cartridge on the thread and screw it into the gun (observe the instructions of the gun manufacturer): The cartridge can be left in the gun until it is completely emptied.
By adjusting directly on the gun, a structural surface as well as two-dimensional coating and profile seam can be produced. There must always be a cartridge in the gun. Never place the gun aside, otherwise the material in the gun will dry out. Do not mix with non-cured PU material. Liability and compatibility with plastics and lacquers must be checked for specific properties.
© 2018 ILS Pty Ltd. ALL RIGHTS RESERVED.